Download ADMS-4B Help File.
Transcript
Programming Other Set Menu Items 83 VLT – Battery voltage (DC source voltage) N/A – Not available at this time Off – Disables the meter Meter Rx Selection - Select the display configuration for the analog meter while the transceiver is receiving. This option corresponds to Menu Item 60 in the radio. Option settings include: SIG – Incoming signal strength CTR – Discriminator center meter VLT – Battery voltage (DC source voltage) N/A – Not available at this time FS – Applies a calibration signal (1 mA for full scale) at the METER jack on the bottom of the radio for adjustment to the calibration of an external meter. This lets you adjust the potentiometer in your metering system so that the external meter reading is full scale. Off – Disables the meter Mic Select – Defines the choice of equipment which will be connected to the mic jack of the radio. The options include Normal – Normal microphone Remote – Options MH-59A8J remote microphone: Note: You cannot address the radio with the Programmer when using the MH-59A8J mic since you cannot access Clone mode when that mic is connected. Functions transferred to the microphone make it impossible to access Clone mode through the keys on the face of the radio. Disconnect the microphone to access Clone mode as described in the Programmer. CAT – Optional CAT system. Note: If you are using the options FC-30 antenna tuner, you can still use the CAT system by connecting the serial data cable to the mic jack. Packet Rate - Set the Packet baud rate to be used. Option settings include 1200 and 9600 bps. The default is 1200 bps. Scan Mode – Set the mode for resuming scanning. Default is Time. Other options include: Time - Scanning will hold for a fixed length of time (set via Scan Resume option) then will resume whether or not the other station is still transmitting. © 2012 RT Systems, Inc