Download ADMS-4B Help File.

Transcript
Programming Other Set Menu Items
83
VLT – Battery voltage (DC source voltage)
N/A – Not available at this time
Off – Disables the meter
Meter Rx Selection - Select the display configuration for the analog meter while the
transceiver is receiving. This option corresponds to Menu Item 60 in the radio. Option
settings include:
SIG – Incoming signal strength
CTR – Discriminator center meter
VLT – Battery voltage (DC source voltage)
N/A – Not available at this time
FS – Applies a calibration signal (1 mA for full scale) at the METER jack on
the bottom of the radio for adjustment to the calibration of an external meter.
This lets you adjust the potentiometer in your metering system so that the
external meter reading is full scale.
Off – Disables the meter
Mic Select – Defines the choice of equipment which will be connected to the mic jack
of the radio. The options include
Normal – Normal microphone
Remote – Options MH-59A8J remote microphone: Note: You cannot
address the radio with the Programmer when using the MH-59A8J mic since
you cannot access Clone mode when that mic is connected. Functions
transferred to the microphone make it impossible to access Clone mode
through the keys on the face of the radio. Disconnect the microphone to
access Clone mode as described in the Programmer.
CAT – Optional CAT system. Note: If you are using the options FC-30
antenna tuner, you can still use the CAT system by connecting the serial data
cable to the mic jack.
Packet Rate - Set the Packet baud rate to be used. Option settings include 1200 and
9600 bps. The default is 1200 bps.
Scan Mode – Set the mode for resuming scanning. Default is Time. Other options
include:
Time - Scanning will hold for a fixed length of time (set via Scan Resume
option) then will resume whether or not the other station is still transmitting.
© 2012 RT Systems, Inc