Download User Manual - LUCKINSlive

SISTEMAS
MEMOKEY 100C
Default codes
For their use, codes are stored in the memory in the following sequence:
POSITION - CODE -ACTION
POSITION: Number assigned to each code in memory (del 00 al 99)
CODE: Number to enter through keypad to carry out the indicated action.
ACTION: What happens after code is entered correctly.
So that the system is up and running, with no need to set any codes, it leaves the factory with
three pre-programmed codes, as shown in the table:
POSITION
(*)
CODE
ACTION
00
CODE 1 (*)
OPEN DOOR
01
CODE 2 (*)
ACTIVATE AUXILIARY DEVICE (if present)
02
CODE 3 (*)
OPEN DOOR AND ACTIVATE AUXILIARY DEVICE
These codes are indicated by a label on the back of the keypad module.
NOTES:
9 Preset codes are exclusive to each set of equipment, so only you will know them.
However, you can change them if you wish.
9 Initially, user codes have 4 digits. For enhanced security, they may be set to 5 or
6 digits length. In this case, the preset codes will no longer be valid.
Pag 4