Download User Manual

KINO-CV-D25501/N26001 SBC
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Before the KINO-CV-D25501/N26001 is installed in the system, the jumpers must be set
in
accordance
with
the
desired
configuration.
The
jumpers
on
the
KINO-CV-D25501/N26001 are listed in Table 4-1.
Description
Label
Type
AT/ATX mode selection
JP2
2-pin header
Clear CMOS
JP3
3-pin header
LVDS1 voltage selection
JP4
3-pin header
LVDS2 voltage selection
JP1
3-pin header
LVDS2 resolution selection
SW1
DIP switch
PCIe Mini/mSATA mode selection
MSATA_SW1
2-pin header
Table 4-1: Jumpers
4.5.1 AT/ATX Mode Selection
Jumper Label:
JP2
Jumper Type:
2-pin header
Jumper Settings:
See Table 4-2
Page 51