Download IT12 User manual

Page 10
CHASSIS ASSEMBLY
NOTE: When mounting wafer tube sockets, be sure to mount each socket from the top of the chassis. If by mistake the
sockets are mounted so the lugs pass through the chassis, they will short to the chassis where they pass through the
mounting hole.
( ) Mount the 9 pin wafer tube socket VI on the underside
of the chassis as shown in Pic-torial 3. Use 3-48 hardware.
(Nolockwash-ers are used with 3-48 hardware.)
( ) In like manner mount the 7 pin wafer tube socket V2 as
shown in Pictorial 3. Use 3-48 hardware.
( ) Mount the C7 condenser mounting wafer on top of the
chassis, observing ground lug slot location as shown in
Pictorial 3. Use 6-32 screws, lockwashers and nuts.
( ) Mount the 2 lug terminal strip X. Use 6-32 hardware.
( ) Turn the chassis over and mount the 2 lug terminal strip at L.
( ) Mount the 2 lug vertical terminal strip T and at the same time mount the 3 lug terminal strip Q. Use 6-32 hardware.