Download New Eagle Automated Testing User Manual

Transcript
Figure 4 - NEAT Console Test Editor
There are several important regions on this screen (labeled in blue, above):





Test Navigator: this is a tree that shows all of your tests, groups, and macros.
Tests are organized in a nested hierarchy. Search for a test or group by typing part
of its name in the Search bar.
Test Editor: this is where a test’s actions are listed. To add actions to a test, drag
the action in from the Action Toolbox or a signal in from the Signals List.
Clean Up Actions Pane: this area can be expanded by clicking the arrow next to
“Clean Up Actions” label. It contains all of the actions that are executed in the cleanup phase of the test. These actions are always executed, even if the test failed or was
aborted due to an error.
Signals List: This lists all of the signals available in the ECU. If both a Test Target
and Coordinator module are configured, then there will be a drop-down at the top of
the Signals List that allows you to switch between the two modules. Search for a
signal by typing part of its name in the Search bar. To set or verify a signal value,
drag the signal name onto the Test Editor.
Action Toolbox: This contains test actions that can be put into your test that do
not deal directly with an ECU signal. See Section 7: Test Actions, below (page 20), for
a description of the operation of each action.
New Eagle Consulting
3588 Plymouth Road, Box #274
Ann Arbor, MI 48105-2603
New Eagle Confidential
PH: 877.234.1410
FAX: 928.395.2114