Download System- and communication configuring D7-SYS
Transcript
Systemsoftware When service makes changes such as these, there are only a limited number of reserves for additional interconnections. The number of additional interconnections is • minimum of 10 additional interconnections, and • maximum of 20 % of the already configured number of interconnections. Example: There are already 5 interconnections from cyclic task T2 to cyclic task T3. For interconnection changes from T2 to T3 there is then a reserve of 10 interconnection changes, as 20 % of 5 = 1, however a minimum of 10. For 100 existing interconnections, there are an additional 20 reserve interconnections, as 20 % of 100 = 20. Limited number of interconnections A differentiation is made between interconnections within a task, between tasks of a CPU and between several CPUs of a station. For operation with several CPUs, an additional differentiation is made between standard- and fast $ signals. For interconnections between tasks of a CPU, the alternating buffer system on the processor is used. The maximum number of interconnections is limited by the main memory expansion stage. Connections between several CPUs of a station are handled via the communication buffer modules. The number of possible interconnections is dependent on the communication buffer module used and the signal types. Further information on the communication buffer modules refer to the " SIMATIC TDC/SIMADYN D hardware" Manual For an MM11 module with 64 Kbyte memory each for the L- and C bus, the following are obtained when using: Signal type Fast $ signals Standard signal Table 2-9 NOTE 2-22 Bytes/interconnection 4 Max. 36 (No. CPUs + 1)* 4) Number of interconnections Approx. 16000 per bus type Min. 1800 per bus type Calculating the maximum number of interconnections If standard and fast interconnections are combined, an appropriately lower number are obtained. System- and communication configuring D7-SYS - SIMADYN D Edition 03.2001
Related documents
SIMADYN D Syst-und-Kom-Projektierung_2003 - sps
SIMATIC Application Module FM 458-1 DP - Internet
4 - Siemens
SIMATIC Applikationsbaugruppe FM 458-1 DP - Service
User Manual
- Siemens
Characterized Lucitone®
PM6 - Siemens
CANopen Interface for SG5 and SG7
1 Compiler, Prom, Versions, Libraries, Options 1.1
Function Blocks FM 458
User Manual - CHRIS - University of Miami