Download Follow These Steps

Appendix A
Logix Base Program Overview
Cfg_ModeTransitions (Configure Mode Transitions)
Cfg_ModeTransitions is used to define acceptable states to transition between modes. In this way you can
allow a mode change, such as from Automatic mode to Manual mode, in the Execute state. The tag consists
of an array of 32 DINT, each corresponding to one of the possible modes.
•
Cfg_ModeName[1] = Cfg_ModeTransitions[1]
•
Cfg_ModeName[2] = Cfg_ModeTransitions[2]
…
•
Cfg_ModeName[31] = Cfg_ModeTransitions[31]
Each individual bit of the DINT corresponds to a specific state as follows.
Bit
State Name
Bit
State Name
00
Not Used – Reserved
16
Completing
01
Clearing
17
Complete
02
Stopped
18
Not Used – Reserved
03
Starting
19
Not Used – Reserved
04
Idle
20
Not Used – Reserved
05
Suspended
21
Not Used – Reserved
06
Execute
22
Not Used – Reserved
07
Stopping
23
Not Used – Reserved
08
Aborting
24
Not Used – Reserved
09
Aborted
25
Not Used – Reserved
10
Holding
26
Not Used – Reserved
11
Held
27
Not Used – Reserved
12
Un-holding
28
Not Used – Reserved
13
Suspending
29
Not Used – Reserved
14
Un-Suspending
30
Not Used – Reserved
15
Resetting
31
Not Used – Reserved
132
Publication IASIMP-QS018C-EN-P — February 2010