Download Example User Manual

XMC-6VLX
USER’S MANUAL
lwip_echo_server_dual
lwip_echo_server_dual – echoes TCP/IP packets sent to it over the Ethernet
ports. This program is used to test the Ethernet ports. Connect the
appropriate copper or fiber Ethernet cable to a host PC and “ping” the XMCV6. The IP address is 192.168.1.10, subnet mask 255.255.255.128 for port 1,
and 192.168.1.138, subnet mask 255.255.255.128 for port 2. Make sure
that the host PC subnet address is also 255.255.255.128 and the host PC IP
address is in the same subnet as the XMC-V6 port that it is attached to. The
Ethernet MAC IDs (mac_ethernet_address1 and mac_ethernet_address2)
are defined in the file main.c. The example program assigns the addresses
00:0A:35:00:01:02 and 00:0A:35:00:01:03. Acromag has reserved two
unique MAC IDs for each XMC-6VLX. The first of two consecutive MAC IDs is
printed on a label attached to the board. To prevent network address
conflicts replace the default addresses in main.c with the MAC ID printed on
the label and the next consecutive address.
srec_bootloader
srec_bootloader – This program is embedded in the example FPGA
configuration bitstream. It is loaded into block RAM memory at
configuration time and begins executing when reset is released. It copies a
microblaze program stored in BPI FLASH (in Motorola “S” record format) to
DDR3 memory, and then executes the program. See section “Running a
Program from BPI FLASH Memory” for instructions on copying a program to
FLASH memory.
IMPORTANT! When building the Acromag modified version of the
SREC_BOOTLOADER program in the Xilinx SDK tool, select the Optimization
Level to ‘None (-O0)’ in the C/C++ Build Settings of the project as shown
below.
peripheral_tests
peripheral_tests – Runs a basic test on each other peripherals instantiated in
the XPS system. The results of each test are displayed on the terminal.
Acromag, Inc. Tel: 248-295-0310
- 68 -- 68 -
http://www.acromag.com
www.acromag.com