Download User Manual

Output Modes
Cover Inserter E
The Cover Inserter E is available as an option on the FN-121/FN-10 finisher.
Load cover sheet paper into this device and use the sheets as front/back covers and/or
insertions for copied sets output to the Main tray or use the sheets as booklet-type covers
for copied sets output to the Booklet tray in the Folding or Stapling & Folding mode.
NOTES:
• Paper loaded into the cover inserter cannot be copied.
• This function is incompatible with cover sheet mode (COVER WITH COPY SHEET and COVER WITH BLANK
SHEET) in Booklet and Sheet/Cover Insertion.
❒ Cover paper size:
Upper tray; 8.5"x11", 8.5"x11"R, 5.5"x8.5"*
Lower tray; 11"x17", 8.5"x14", 8.5"x11", 8.5"x11"R, 5.5"x8.5" *
*5.5"x8.5" paper is available in long edge feeding only.
❒ Cover paper weight: 13 ~ 110 lb (200g/m2 cover paper)
❒ Tray capacity: 200 sheets (110 lb (200g/m2 cover paper) or 30mm thick for both trays
❒ Incompatible Conditions: Output to Secondary (sub) tray, Punch using PK-2 Punch kit, Z-Folding,
Sheet/Cover Insertion, Cover sheet mode in Booklet, Transparency Interleave
❒ Incompatible Conditions with INSERTION selected: Group, Sheet/Cover Insertion, Combination,
Booklet, Transparency Interleave, Image Insert, Book Copy, Non-Image Area Erase, Repeat,
AUTO Layout, Overlay
Copied set with covers and insertions
Cover sheet
Copied set with
covers attached in
Staple-sort mode
Copied sets with cover
attached in Folding or
Stapling & Folding mode
7-24