Download Opcode Studio 4 MIDI Interface User Manual from

COPYRIGHT
This software and manual are copyrighted
©1995 by Opcode Systems, Inc. with all rights
reserved. The software or manual may not be
copied, in whole or part, without the express
written consent of Opcode Systems, Inc.
except for the original purchaser to make
backup copies. Unauthorized duplication is
prohibited.
This software is protected by both United
States Copyright Law and International Treaty
provisions. Opcode Systems, Inc. grants the
user this license, and use confirms agreement.
The Studio 4 and OMS software may be used
with the Studio 4 by any number of users, and
may be used on more than one computer at a
time. If you have any problems with the software or hardware, please consult the user’s
guide first. Consult the dealer from which you
purchased the Studio 4, as they are your best
local source of assistance.
If you still have a problem, call Opcode Systems, Inc. Technical Support Line at (415) 8563331. See the Studio 4 manual for details.
WARNING
NOTE: This equipment has been type tested
and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interference in residential installations. This
equipment uses, and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to
radio or television equipment reception, which
can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Move the equipment away from the receiver
• Plug the equipment into an outlet on a circuit different from that to which the receiver is
powered.
If necessary, the user should consult the
dealer or an experienced radio/television technician for additional suggestions.
CAUTION: Only equipment certified to comply
with Class B (computer input/output devices,
terminals, printers, etc.) should be attached to
this equipment, and must have shielded interface cables.
Finally, any changes or modifications to the
equipment by the user not expressly approved
by the grantee or manufacturer could void the
users authority to operate such equipment.
ACKNOWLEDGEMENTS
Studio 4 manual written by Gregory A. Simpson and Jon Drukman.
OMS, OMS Setup, Studio Patches Editor, and
Studio 4 Driver by Doug Wyatt.