Download Portal Software User Guide

Chapter 1. Initial Software Installation and Setup
Basic Portal Software Configuration
Note that to be able to check these devices in the Quick Setup, you must abide by default wiring recommendations.
See Card Access Controller Wiring Diagram and Connecting Inputs to Controller, Connecting Outputs to Controller
sections for more information.
d. Check off all used devices under Other functions category: Low battery, Power failure, Tamper.
Please note that an additional battery must be purchased to use Low battery and Power failure functions.
Portal Card Access chassis (P-PORTALCHASSIS) comes with a N/C tamper switch for Tamper detection. All these
inputs must be properly connected to the Controller board in accordance with wiring recommendations. See Card
Access Controller Wiring Diagram and Connecting Inputs to Controller, Connecting Outputs to Controller sections
for more information.
e. Click OK once the Controller setup is complete.
f. Repeat above steps for all detected Controllers.
9. The configured access points will be added as separate entries in the Controller setup. The Controller panel will be
displayed in the Hardware Monitor below.
This completes the initial Controller installation.
7
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/