Download STADIA Integration Hub

Transcript
Marathon/Integration Hub User’s Manual
Messages
Table C-1. Screen Display Messages (continued)
Message
Message Type
Explanation
LAN RESET: VIA COMMAND
FACILITY
Event
A LAN module reset has been initiated at the
Command Facility.
LAN RESET: VIA LAN MODULE
Event
A user on the LAN side has initiated a LAN
module reset.
LAN RESET: LAN–>LAN
RELOAD
Info
The Integration Router Module is resetting in
preparation for code download via the LAN
(from a Bootp/TFTP server).
LAN RESET: WAN–>LAN
RELOAD
Info
The Integration Router Module is resetting in
preparation for code download via a CCM
async port.
ni LINE ALARM ci
Alarm
Link ci at node ni has a line alarm, indicating a
high line error rate.
ni LINE ALARM LINK ci
Alarm
If only port number displays: Excessive line
error rate between the local unit and the
attached frame relay switch.
If the port and DLCI number displays:
Information between the units using ci is being
lost. Does not apply to information sent in
excess of the configured committed
information rate (CIR) or burst sizes (Bc, Be).
Possible causes,
D CRC error
D Frame relay discard due to congestion
LINK DOWN ci
Alarm
Local unit has timed out (40 seconds) waiting
for sync to be acquired on link ci. Check the
cabling, modem and remote unit for errors.
LINK RATES RESTRICTED TO
19.2 KBPS OR LESS
Info
You have attempted to configure a data rate
higher than 19.2 Kbps on port A3 of the
Marathon 5K Turbo. This is not permitted;
select a lower rate.
LOCAL CHANNEL
CONFIGURATION DISABLED
Info
Local Channel Configuration menu cannot be
accessed by the async port requesting it.
LOCAL FOX
Diag
Port has been placed into a local fox loopback
test.
ni LOCAL LINK RESTART ci
Event
D
D
Node ni on link ci has been restarted.
Local node ni initiated a reset of the DLCI
using the reported ci.
ni LOCAL SYSTEM RESET
Alarm
Local unit has been reset.
LOCAL TEST, ECHO INPUT
Diag
Port has been placed into a local echo
loopback test.
LOCKED PARAMETER
Event
This parameter is locked out by the hardware
configuration.
C-9