Download User`s Manual

Transcript
PC terminal to set trigger source:
TRIGger:SOURce BUS
By internal trigger: The internal trigger is the default trigger mode for
the Remote Interface Operation. In the internal trigger mode, a trigger
signal will be issued whenever the multimeter is in the wait-for-trigger
state. To set the internal trigger, use the following command from your
PC terminal:
TRIGger:SOURce IMMediate
4.2.3
Trigger Setting
In M3510A/11A, you can specify a variety of trigger settings including
the number of samples per trigger, the number of triggers per event,
reading hold, and the trigger delay for your measurements.
A. Number of samples on each trigger
By default, M3510A/11A takes only one reading on each trigger, but you
can instruct the multimeter to take specific number (up to 2000) of
readings each time it receives a trigger. The defined input setting is
stored in a volatile memory which will be cleared after the meter has
been turned off and the default value will be restored. You can set the
number of samples on each trigger through front panel or the remote
interface.
Front Panel Operation
1.
Press SHIFT+CONFIG button.
2.
Set a defined parameter via the procedure TRIG SYS > TRIG CNT >
ENTER.
3.
△and ▽ buttons to increase or
using ◁ and ▷ buttons to move
Set the desired number by pressing
decrease the number, and
through the digits. Press ENTER to set the number.
Remote Interface Operation
Use the following command to set the number of samples from your PC
64