Download Universal Library for LabVIEW TM

Transcript
AOut.VI
Description:
Sets the value of a D/A output.
Summary:
Inputs:
BoardNum [U32] - The board number when installed with InstaCal. Can be 0 to 100.
Channel [I32] - A/D channel number
DataValue [U16] - Value to set D/A to
Range [I32] - A/D Range code
Outputs:
ErrCode [I32] - Error code
Explanation of the Arguments:
BoardNum - refers to the board number associated with the board when it was installed with the configuration program.
The specified board must have a D/A.
Channel - The maximum allowable channel depends on which type of D/A board is being used.
DataValue - Must be in the range 0 - N where N is the value 2 ^ Resolution - 1 of the converter.
Range - If the selected A/D board does not have a programmable range feature, this argument will be ignored. Otherwise the gain
can be set to any of the following ranges that are supported by the selected A/D board. Refer to board-specific information for the list
of ranges supported by each board.
BIP10VOLTS
BIP5VOLTS
BIP2PT5VOLTS
BIP1PT67VOLTS
BIP1PT25VOLTS
BIP1VOLTS
BIPPT625VOLTS
BIPPT5VOLTS
BIPPT1VOLTS
BIPPT05VOLTS
BIPPT01VOLTS
BIPPT005VOLTS
+/- 10 volts
+/- 5 volts
+/- 2.5 volts
+/- 1.67 volts
+/- 1.25 volts
+/- 1 volts
+/- 0.625 volts
+/- 0.5 volts
+/- 0.1 volts
+/-0.05 volts
+/- 001 volts
+/- 0.005 volts
UNI10VOLTS
UNI5VOLTS
UNI2PT5VOLTS
UNI2VOLTS
UNI1PT67VOLTS
UNI1PT25VOLTS
UNI1VOLTS
UNIPT1VOLTS
UNIPT01VOLTS
MA4TO20
MA2TO10
MA1TO5
MAPT5TO2PT5
0 to 10 volts
0 to 5 volts
0 to 2.5 volts
0 to 2 volts
0 to 1.67 volts
0 to 1.25 volts
0 to 1 volts
0 to 0.1 volts
0 to 0.01 volts
4 to 20 mA
2 to 10 mA
1 to 5 mA
0.5 to 2.5 mA
For Simultaneous-Update Boards: If you have set the simultaneous update jumper for simultaneous operation, you should use
AOutScan.VI for simultaneous update of multiple channels. AOut.VI always writes the D/A data then reads the D/A, which causes
the D/A output to be updated.
18