Download SR470 Laser Shutter Controller

1.3
The SR470 Rear Panel
1 – 19
10.
11.
12.
13.
Count step size: 1
Aux I/O configuration: Manual, high
Alarm: Audible
Display: On
Recalling factory default settings this way does not affect the interface
configuration. The interface configuration can be restored to factory
defaults by power cycling the unit with the [ENet] ([6]) key pressed.
In this case, the following interface setup is recalled:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
RS-232: Enabled
RS=232 baud rate: 9600
GPIB: Enabled
GPIB address: 8
TCP/IP interface: Enabled
IP Address: 0.0.0.0
Subnet: 0.0.0.0
Router: 0.0.0.0
Link speed: 100 Base-T
VXI-11, Telnet, and Raw socket interfaces enabled.
Figure 1.3: The SR470 rear panel.
1.3
The SR470 Rear Panel
The rear panel of the SR470 (see Figure 1.3) provides input and
output connectors for controlling the shutter, a TTL sync output, an
alarm output, two auxiliary I/O ports, a chassis-grounded binding
post, three remote interfaces, and the power entry module.
SR470
Shutter Controller