Download User Guides - Digital Projection
Transcript
Digital Projection HIGHlite Cine 260, 1080p 330 User Manual Mounting the projector 2. Installation Notes The four adjustable feet under the chassis allow the projector to be lowered onto a flat surface without any danger of hands being trapped between the bottom frame and the surface. Ceiling mounting The projector is designed to be used on a flat surface, but it can be suspended from a ceiling. Four M4 mounting holes with a 0.7mm pitch are provided under the projector to allow bolting to a ceiling mounting plate. Dimensions in mm BEFORE INSTALLING THE PROJECTOR, READ ALL THE WARNINGS BELOW AND ALL THOSE IN IMPORTANT INFORMATION AT THE FRONT OF THIS MANUAL. The projector weighs approximately 20 kg (44 lbs). Use safe handling techniques when lifting the projector. Make sure that the surface, ceiling or rigging that is to support the projector is capable of supporting the weight of the projector. Backup safety chains or wires should always be used with ceiling mount installations. To use the projector upside down, set Ceiling mode to On, in the System menu, to invert the image. Level adjustment If the projector is to be operated from a flat surface such as a projector table, then adjustment of projector level should be made by turning the four feet under the chassis. Do not tilt the projector more than ±8.5° forwards and backwards when in use, as this may cause serious lamp failure, damage the lamp module and cause extra cost on replacement. The projector my be tilted left and right as necessary. ±8.5° Ideally, the projector should be positioned perpendicular to the screen, and the lens shift controls used to align the image with the screen, to maintain a geometrically correct image. ±8.5° Rev D July 2014 Page 2.15