Download User Guides - Digital Projection

Transcript
Digital Projection HIGHlite
Cine 260, 1080p 330 User Manual
Mounting the projector
2. Installation
Notes
The four adjustable feet under the chassis allow the projector to be lowered onto a
flat surface without any danger of hands being trapped between the bottom frame
and the surface.
Ceiling mounting
The projector is designed to be used on a flat surface, but it can be suspended
from a ceiling. Four M4 mounting holes with a 0.7mm pitch are provided under the
projector to allow bolting to a ceiling mounting plate.
Dimensions
in mm
BEFORE INSTALLING THE
PROJECTOR, READ ALL THE
WARNINGS BELOW AND
ALL THOSE IN IMPORTANT
INFORMATION AT THE
FRONT OF THIS MANUAL.
The projector weighs
approximately 20 kg (44 lbs).
Use safe handling techniques
when lifting the projector.
Make sure that the surface,
ceiling or rigging that is
to support the projector is
capable of supporting the
weight of the projector.
Backup safety chains or
wires should always be
used with ceiling mount
installations.
To use the projector upside down, set Ceiling mode to On, in the System menu, to
invert the image.
Level adjustment
If the projector is to be operated from a flat surface such as a projector table, then
adjustment of projector level should be made by turning the four feet under the
chassis.
Do not tilt the projector more
than ±8.5° forwards and
backwards when in use, as
this may cause serious lamp
failure, damage the lamp
module and cause extra
cost on replacement. The
projector my be tilted left and
right as necessary.
±8.5°
Ideally, the projector should be positioned perpendicular to the screen, and the lens
shift controls used to align the image with the screen, to maintain a geometrically
correct image.
±8.5°
Rev D July 2014
Page 2.15