Download Evolution 500 User Manual

Transcript
Nicolet Evolution 500 User Manual
5.2
Connecting up a Computer based Nicolet Evolution 500 system
On a computer based Evolution 500 system the printer supplied must be connected to
parallel interface connector 1 (LPT1) whilst a plotter must be connected to serial interface
connector (COM2).
(1) Using the cable supplied with the PC software, connect the Evolution 500
spectrophotometer to the computer as shown on Fig 5.2.
(2) Check all PC interconnections previously connected. (Section 4.3.2.)
Ensure the connectors are firmly secured to their respective mating connectors by
tightening the jackscrews evenly on each side.
(3) If required, connect the printer supplied to the parallel interface connector LPT1 on the
rear of the computer base unit using the cable supplied with the printer. At one end of
the cable is a 25-way `D' type plug. Fit this into the PARALLEL 1 (LPT1) socket of the
computer drawing the plug carefully into the socket by tightening each jackscrew
alternately, a turn at a time. Connect the 36-way plug at the other end of the cable to
the mating socket on the printer. Secure in position using the clips on the printer.
(4) If required, connect the plotter to the serial interface connector COM2 on the rear of
the computer base unit using the cable supplied with the plotter. Ensure the
connectors are firmly secured to their appropriate mating connectors at both ends of
the cable.
5.2.1
Setting up the Printer/Plotter
Various printers/plotters may be used, each being supplied with its own manual which
should be consulted for full instructions on setting up and operation.
When using Vision software on the PC, any parallel printer supported by Windows
™ can be used to obtain hard copy output.
19
Issue 1 (August 2003)