Download MEK 4S

GB
7
MAINTENANCE
Note:
All warranty undertakings given by the supplier cease to apply if the customer
attempts to rectify any faults on the machine during the warranty period.
Regular maintenance is important for safe and reliable operation.
S
Regularly blow the wire liner clean and clean the gas nozzle.
S
The wear components of the wire feed mechanism should be replaced at regular
intervals in order to ensure reliable wire feeding.
Note that using excessive pressure on the wire feed rollers can cause excessive
wear to the pressure roller, feed roller and wire liner.
The brake hub
The hub is adjusted when delivered, if
readjustment is required, follow the instructions
below. Adjust the brake hub so that wire is slightly
slack when wire feed stops.
S
Adjusting the braking torque:
S
Turn the red handle to the locked position.
S
Insert a screwdriver into the springs in the hub.
Turn the springs clockwise to reduce the braking torque
Turn the springs anticlockwise to increase the braking torque. NB: Turn both
springs through the same amount.
8
ORDERING SPARE PARTS
Spare parts are ordered through your nearest ESAB representative, see back cover.
When ordering spare parts, please state machine type and number as well as designation and spare part number as shown in the spare parts list.
This will simplify dispatch and ensure you get the right part.
bm24e
-- 42 --