Download Remote Device Connectivity Software User Manual

To add new monitors:
Note: Only an agency administrator may add new monitors.
1 . Select “Add.” Enter the necessary information. “Monitor ID” is a required field used by the
Central Server to identify all monitor communications with the patient. The ID serial
number is located on the back of the monitor. This number can be found in the upper right
corner and is in the format HVPxxxx or CJxxxxx; where x is a number.
2 . The serial number must be entered correctly to ensure the Central Server will recognize
the monitor to enable communications.
3 . Select “Multiple Patient Mode” if this monitor is intended to be used in multiple-patient
mode by multiple patients in a clinical setting. A monitor will default to single-patient mode
unless changed in Remote Device Connectivity.
4 . Use the pull-down menu to select the time zone where the monitor will be located,
and check the box if that region utilizes daylight saving time.
To edit a monitor/change mode setting:
Note: Only an agency administrator may edit a monitor.
1. Double-click the monitor to be edited, or highlight the monitor to be edited and select
“Edit.”
2. Change the information and/or mode setting.
3. Select “Save & Close.”
DL-00033 Rev. 10
21