Download OneFS 6.5.5 User Guide
Transcript
Events and event notifications 900080033 Redundant power supply failure. Details The issue is caused by one of the following conditions: • • One of the power supplies in the node is not providing power. The power (AC) provided from the electrical outlet to one or both power supplies is insufficient. The LED light indicates the power supply status. (The LED light is on the inside of the node, but is visible on the back panel.) • • • • • Steady green (applies to all node models): Status is good. Blinking green (applies only to 4U (36000X, 3600NL, 72000X, and 72000NL) nodes): The electrical outlet is providing sufficient AC to the power supplies, but the node is turned off. Steady amber (applies only to all X- and S-series nodes): The electrical outlet is providing sufficient AC to the power supplies, but the node is turned off. Blinking amber (applies only to all X- and S-series nodes): There is a power supply failure. Light is off (applies to all node models): There is no or insufficient AC power. Administrator Response Perform the following steps: 1. If a single node reports the issue, determine the cause of the issue by performing the following steps: a. Determine if the electrical outlet is functioning properly by plugging the power cable into a different electrical outlet. b. If the issue is not resolved by using a different electrical outlet, move the power cable from the power supply that reports the failure to the power supply of a node that does not report a failure. If the cable is the issue, replace the cable. ! Caution: Do not move the power cable to another power supply for the same node. c. If the issue persists, take one power supply out of a different node and replace it with the power supply that reports the problem. ! Caution: Do not switch power supplies in the same node. Doing so causes there to be a time when neither power supply is in the node. • • If the issue follows the power supply, the power supply needs to be replaced. If the issue stays with the node, contact Isilon Technical Support for help troubleshooting the node. d. If the preceding steps do not resolve the issue, contact Isilon Technical Support. 2. If multiple nodes report power supply issues, confirm the health of power subsystem. The issue is likely environmental. Check each of the following items: • • • • Supplied voltage. Power quality, such as the correctness of the voltage and the smoothness of the waves. Uninterruptible Power Supply (UPS) health, such as the ability to provide clean and consistent power. UPS battery health. If you need help troubleshooting the issue, contact Isilon Technical Support. 258 © 2011 Isilon Systems, LLC.