Download SCADASense 4203 DR - Control Microsystems
Transcript
Ripple Transient Protection Response Time 9.8 Less than 10µs for 10% to 90% signal change Turbine Meter Counter Input Type Turbine Meter Sensitivity Transient Protection Isolation 9.9 Transient: 2.5kV surge withstand capability as per ANSI/IEEE C37.90.1-1989 Counter 1 Single turbine meter input. Designed for use with low voltage, turbine meter outputs. Minimum input 30mVp-p at 5-50Hz. Minimum input 150mVp-p at 150Hz. Minimum input 650mVp-p at 5kHz. Minimum input 750mVp-p at 10kHz. Maximum input 4Vp-p using internal amplifier. 2.5kV surge withstand capability as per ANSI/IEEE C37.90.11989 Common ground return connected to Chassis Ground. Digital Counter Input Type Frequency Input Thresholds Contact Resistance Transient Protection Isolation 9.10 Counter 0. Dry contact input. Wetting current typically 5mA. Contact closure to ground is ON. Open input is OFF. 0-10kHz. 0.8V typical turn on input voltage. Less than 0.4V guaranteed turn on input voltage. 1.5V typical turn off input voltage. Greater than 2.0V guaranteed turn off input voltage. ON input requires less than 100Ω contact resistance. OFF input requires greater than 1kΩ contact resistance. 2.5kV surge withstand capability as per ANSI/IEEE C37.90.1-1989 Common ground return connected to Chassis Ground. Digital Output Type Load Range Transient Protection Isolation Note Open drain sinking 500mA maximum 30VDC maximum 2.5kV surge withstand capability as per ANSI/IEEE C37.90.11989 Common ground return connected to Chassis Ground. Digital Output available on version 5 and later controller hardware. SCADASense 4203 DR- Installation and User Manual October 19, 2007 59