Download TP01 Manual version 1509

Transcript
Hukseflux Thermal Sensors
1 Theory
The following chapter gives a summary of the TP01 theory. A
more extensive explanation can be found in an appendix of this
manual.
As indicated in the introduction, the TP01 design is a modification
of the well known non-steady-state probe. This technique utilizes
the temperature measurement around a heating wire to analyze
soil properties.
All non-steady-state probes are based on the same
phenomenon: that one can determine the thermal properties of
a medium from the temperature response to heating. After an
initial transition period, the temperature rise close to the heater
depends only on the thermal conductivity of the surrounding
medium, and no longer on heat capacity. This method avoids
the necessity to reach a true thermal equilibrium with constant
temperatures. Non-steady-state techniques are fast and also
there is no need for careful sample preparation. Sensors based
on this principle are therefore suitable for quick experiments and
also for field use.
Provided that the thermal mass of the sensor itself is small,
during the initial transition period the time response of this type
of probe is proportional to the thermal diffusivity of the
surrounding medium.
TP01 uses a new technique which depends heavily on a very
sensitive temperature gradient sensor. A differential temperature
sensor (2 thermopiles) measures the radial differential
temperature around the central heating wire with recordbreaking sensitivity. This technique is easier to employ than
conventional techniques because the interpretation of the signals
is very easy. The principle of measurement is clarified in figures
0.1, 1.1 and 1.2.
TP01 Manual version 1509
page 8/45