Download PCA-6157
Transcript
a. Make sure that all the SCSI devices are configured at different ID numbers (boot drive should have lowest ID). b. Make sure both, but only the ends of the SCSI bus are terminated. c. Make sure the device driver is listed in CONFIG.SYS (and loaded when booting). • DEVICE DRIVER DOES NOT SEE ONE OF THE SCSI DEVICES. a. Reboot the computer. b. Make sure the SCSI devices have different ID numbers (boot drive should have lowest ID). c. Make sure bot but only the ends of the SCSI bus are terminated. d. Check the cable and power connections. • OS/2 INSTALLS TO AN IDE DRIVE IN THE SYSTEM INSTEAD OF TO THE SCSI DRIVE. a. The IDE drive must be physically disconnected and disabled in CMOS setup before attempting to install to a SCSI drive. • NCR ADD ERROR: ONE OF YOUR HOST ADAPTERS IS MALFUNCTIONING. a. Typically an interrupt problem. System BIOS may not be assigning interrupt properly. Check CMOS setup for PCI slot setup. Assign or change interrupt assigned to the slot in which the NCR adapter is placed. Reboot computer. Important Additional Information High Speed Tape Drive Support High-speed tape backup has become essential to computer systems as the capacities of hard disk drives have increased. For example, the NCR OS2CAM.ADD driver provides support for the Sytos Plus Version 1.35 (or above) Tape Backup System, and will function properly with the Sytos Plus software. 74 PCA-6157/6157L User's Manual