Download 3rd CONTROL SYSTEM USER MANUAL

Chapter 4 Samples
In case of mass production, this function will improve the efficiency significantly. The feeding
function is designed for flexible materials specially. Before cutting, please check the flatness and
trimness of the material.
The third controller supports four channels motor, which are X, Y, Z and A; axis A is used by
mesh belt, axis Z is used by feeding roller in case of single laser head and by second cutting head
in case of double laser heads.
4.1 Single laser head
Single laser head processing means that only one laser head is used for processing.
4.1.1 Array graph processing
During array graph processing, two feeding modes are available, which are progressive and
breadth. Suppose that the graph to be processed is shown in Fig.4-1:
Fig.4-1
The steps follow:
A. Draw a 600 wide and 600 high graph in the upper computer software, as shown in
Fig.4-2:
Fig.4-2
Set the axis X travels for the graph area and machine breadth to 1600mm and set the axis Y
travels to 1000mm. (“Tool” – “Machine setting” – “set System parameter” – “Set Machine Para” –
“System Para” – “soft limit”).
B. Press “SET” on the control panel to Enter “parameter management”:
Select “Config” and Enter “Working Para” in the submenu;
- 43 -