Download Configuration Guide

Configuration Steps for an Internet Connection
Table 18-2
Ethernet Port Parameter Values
Setting
Command
IP address
set ether0 address 192.168.200.1
Netmask
set ether0 netmask 255.255.255.0
Broadcast address
set ether0 broadcast high
After configuring the Ethernet interface, enter the following commands to reset it and
save the configuration:
Command> reset ether0
Command> save all
For more information on Ethernet interface parameters, refer to Chapter 4,
“Configuring the Ethernet Interface.”
Serial Port Settings for Dial-Out
For continuous dial-out on a serial port, configure the port with the values shown in
Table 18-3.
Table 18-3
Serial Port Values for Continuous Dial-Out
Setting
Command
Port type
set s1 network dialout
Protocol
set s1 protocol ppp
Speed 1
set s1 speed 1 115200
Speed 2
set s1 speed 2 115200
Speed 3
set s1 speed 3 115200
Modem control
set s1 cd on
Hardware flow control
set s1 rts/cts on
Software flow control
set s1 xon/xoff off
Dial group
set s1 group 1
Using Internet Connections
18-5