Download 1 - HP

chug.bk : ch08 Page 177 Tuesday, November 25, 1997 12:49 PM
Changing the default copy size
The default copy size is the size to which copies are normally
reduced or enlarged. If you keep the factory default size set to 100
percent, all copies will be the same size as the original document.
You probably will not need to change this setting and should leave it
set to 100 percent.
Note
If you only want to change the copy size for the job you are currently
copying, see “Reducing or enlarging copies” in chapter 5.
To change the default copy size
1
Press ENTER/MENU.
2
Use the < and > keys to select User Defaults and press
ENTER/MENU.
3
Use the < and > keys to select Copy Size and press
ENTER/MENU.
4
Enter how much you want to reduce or enlarge copies normally.
You can choose from 50 to 200 percent.
5
Press ENTER/MENU to save your selection.
6
Press STOP/CLEAR to exit the Menu settings.
Changing the language on the display panel
Use this procedure to have the control panel display messages in a
language other than the default.
To change the language on the display panel
EN
1
Press ENTER/MENU.
2
Use the < and > keys to select User Defaults and press
ENTER/MENU.
3
Press ENTER/MENU to select Language .
4
Use the < and > keys to select the language you want. You can
choose English , Francais , Deutsch , or Nederlands .
5
Press ENTER/MENU to save your selection.
6
Press STOP/CLEAR to exit the Menu settings.
8 Managing Basic Features 177