Download Cisco Physical Security Multi Services Platform User Guide

Transcript
CH A P T E R
3
Mounting the Multi Services Platform in a Rack
The Multi Services Platform is designed to be installed in a standard 19-inch rack. The server ships with
one set of rail assemblies and the mounting screws that you need to secure the server in a rack.
This chapter describes how to rack mount the Multi Services Platform. It includes these sections:
•
Preparing for Installation, page 3-1
•
Rack Mounting, page 3-2
Preparing for Installation
Before you install the Multi Services Platform in a rack, review the following guidelines:
Choosing a Location
•
Leave enough clearance in front of the rack to enable you to open its front door completely
(approximately 25 inches).
•
Leave approximately 30 inches of clearance in back of the rack to allow for sufficient air flow and
ease of servicing.
•
The Multi Services Platform is intended for installation in a restricted access location, such as a
dedicated equipment room or service closet.
Rack Precautions
•
Ensure that the leveling jacks on the bottom of the rack are extended to the floor with the full weight
of the rack resting on them.
•
In a single rack installation, attach stabilizers to the rack.
•
In a multiple rack installation, couple the racks to each other.
•
Make sure that the rack is stable before extending a component from the rack.
•
Extend only one component from a rack at a time. Extending two or more components may cause
the rack to become unstable.
General Precautions
•
Review the electrical and general safety precautions that come with the components that you add to
your chassis.
•
Determine the placement of each component in the rack before you install the rails.
•
Install the heaviest components on the bottom of the rack first, then work up.
Cisco Physical Security Multiservices Platform User Guide
OL-17301-02
3-1