Download Cisco Physical Security Multi Services Platform User Guide
Transcript
CH A P T E R 3 Mounting the Multi Services Platform in a Rack The Multi Services Platform is designed to be installed in a standard 19-inch rack. The server ships with one set of rail assemblies and the mounting screws that you need to secure the server in a rack. This chapter describes how to rack mount the Multi Services Platform. It includes these sections: • Preparing for Installation, page 3-1 • Rack Mounting, page 3-2 Preparing for Installation Before you install the Multi Services Platform in a rack, review the following guidelines: Choosing a Location • Leave enough clearance in front of the rack to enable you to open its front door completely (approximately 25 inches). • Leave approximately 30 inches of clearance in back of the rack to allow for sufficient air flow and ease of servicing. • The Multi Services Platform is intended for installation in a restricted access location, such as a dedicated equipment room or service closet. Rack Precautions • Ensure that the leveling jacks on the bottom of the rack are extended to the floor with the full weight of the rack resting on them. • In a single rack installation, attach stabilizers to the rack. • In a multiple rack installation, couple the racks to each other. • Make sure that the rack is stable before extending a component from the rack. • Extend only one component from a rack at a time. Extending two or more components may cause the rack to become unstable. General Precautions • Review the electrical and general safety precautions that come with the components that you add to your chassis. • Determine the placement of each component in the rack before you install the rails. • Install the heaviest components on the bottom of the rack first, then work up. Cisco Physical Security Multiservices Platform User Guide OL-17301-02 3-1