Download CapiScope HVCS User Guide Preface
Transcript
KK Technology CapiScope HVCS User Guide Maintenance and Service Cleaning Recommendation Close the CapiScope Analysis program switch off and unplug the CapiScope HVCS. Use only 70% isopropyl alcohol or SANI-CLOTH HB wipes to clean the external surfaces of the CapiScope HVCS between uses to avoid contamination and the transmission of disease. CAUTION: Do NOT use excessive liquid which might ingress into the device. CAUTION: Do NOT use acetone to clean any part of the CapiScope HVCS. CAUTION: Do NOT attempt to sterilize the CapiScope HVCS using heat, steam, immersion, gas, or radiation. Servicing All repairs on products under warranty must be performed or approved by KK Technology. Unauthorized repairs will void the warranty. In addition, whether or not covered under warranty, any product repair shall exclusively be performed by KK Technology certified service personnel. If the product fails to function properly, or if you need assistance, service, or spare parts, contact KK Technology. Before contacting KK Technology, try to duplicate the problem, and check all accessories to ensure that they are not causing the problem. When calling, please be prepared to provide: Product name and model number and complete description of the problem. Serial number of your product (if applicable). Complete name, address and phone number of your facility. For out-of-warranty repairs or spare parts orders, a purchase order (or credit card) number. For parts orders, the required spare or replacement part numbers. If your product requires warranty, extended warranty, or non-warranty repair service, please call KK Technology. A representative will assist you troubleshooting the problem and will make every effort to solve it over the phone, avoiding potential unnecessary returns. In case a return cannot be avoided, the representative will record all necessary information and will provide a Service Notification number, as well as the appropriate return address. The Service Notification number must be obtained prior to any return. If you have to return goods for service, follow these recommended packing instructions: Remove all hoses, cables, sensors, power cords, and ancillary products (as appropriate) before packing, unless you suspect they are associated with the problem. Wherever possible use the original shipping carton and packing materials. 30/03/2015 hvcs-UG20150329.odm Page 11