Download Trimble 5600-series User Guide

Laser Safety Information
Before using the instrument, make sure that you understand this
User Guide, as well as all equipment and jobsite safety
requirements.
Laser Safety
This equipment has been tested and found to comply with IEC
60825-1 January 2001, 21 CFR 1040.10 and 1040.11 except for
deviations persuant to Laser Notice no. 50, dated May 27, 2001.
C
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous LED or
Laser radiation exposure. As with any bright light source, such as
the sun, electric welding arcs or arc lamps, common sense
applies. DO NOT look into the laser aperture when the laser is on.
For further information regarding safe use of lasers, refer to the
IEC standard 60825-1 January 2001.
Queries
Address any questions you may have about laser safety to:
Trimble
5475 Kellenburger Road
Dayton, OH U.S.A. 45424-1099
Attention: Laser Safety Officer, Quality Assurance Group
Phone (937) 233-8921 ext 824 or (800) 538-7800
Fax (937) 233-9661
v