Download IPMIView User`s Guide


Tool Bar functions
The tool bar provides the following features as shown in Figure 14-2.
Figure 14-2
o
o
o
o
o
o
Start: starts the Trap Receiver.
Stop: stops the Trap Receiver.
Save: saves the traps received into a file.
Load: loads a saved trap file into the Trap Receiver.
Clear: clears all the traps in the trap list.
Email: displays an “Email-Alert Settings” dialog box (see Figure 12-3). Fill the “SMTP
server”, “From (email address)” and “To (email address)” fields. The “From” and “To”
addresses must be valid in the SMTP server. If the SMTP server requires authentication,
please enter the username and password. Once entering needed information, click the <Test>
button to verify if your email works properly.
Figure 14-3

Category
There are three categories including: Sender, Community and Sensor as shown in Figure 14-4. The
Sender page lists all sender IP addresses. The Community page lists all SNMP communities. The Sensor
page lists all sensor types from the traps. Clicking on each category type will act as a filter for all traps
in the traps list. Click the <All> button to cancel all filters.
56