Download User`s Manual
Transcript
C d 39Using Test and Service Mode 6 This chapter explains the different procedures you can perform while the 4420 or 4440 printer is in Test and Service mode. Use Test and Service mode on the printer to print test labels, perform special procedures such as cloning, and change some configuration commands. Using Test and Service Mode Procedures When you press the Feed/Pause button, the current function pauses and the printer enters Test and Service mode and executes all Test and Service mode procedures. The printer remains in Test and Service mode until you turn off the power and reset the DIP switches. To enter Test and Service mode 1. Turn off the printer. 2. Press and hold the Feed/Pause button while turning on the power. The printer prints out a hardware configuration label and then enters Data Line Print mode. 3. Set the DIP switches to the test or service function you wish to perform. See the following table for a list of the DIP switch settings. 4. Press the Feed/Pause button. The test begins immediately. 5. If you want to perform another function, change the DIP switch settings and press the Feed/Pause button. The function the printer is currently executing terminates, and the printer performs the new function. To exit Test and Service mode 1. Turn off the printer. 2. Reset the DIP switches to their original settings. 3. Turn on the printer. Use the information in the following table to set the DIP switches for the appropriate Test and Service mode function you want to perform. 6-3