Download Users Manual - Ardy Electronics Ltd

If parameter 9 is set to 1 or 2 (see section 5.1.4) is it possible to but SLF2000 in the
state :
ENCRYPTION =AUTO
READY
In this state the SLF2000 encryption system will automatically turn encryption ON
when transmitting fax messages and the receiving fax has a SLF2000 installed . If
parameter 9 is set to 2 the system will turn encryption ON automatically only if the
receiving system has the same Master Smart-Card identity as the transmitting
system (see 5.1.1 ) .
REMARK : This function only works when both the receiving and the transmitting
system has version 2.4 or higher of the software .
With parameter 9 set to 1 the different ON/OFF/AUTO modes (parameter 2 ) will
function as described below :
Value
Start-up with
Time-out
YES,ON and OFF
5 minutes .
YES,ON and OFF
5 minutes .
YES,AUTO and OFF
5 minutes
0
Encry =AUTO
1
Encry =AUTO
2
Encry = ON
3
Encry =AUTO
NO
4
Encry = ON
NO
5
Encry = ON
6
Encry =AUTO
NO
YES,OFF 5 minutes
7
Encry =OFF
Remark
Encry=ON only with
User-Card *
Default
Only ON allowed
Only OFF and
AUTO allowed
AUTO not allowed
The automatic turn on of encryption only works when the display shows
"ENCRYPTION=AUTO" .
In the state ENCRYPTION=ON or OFF will the system stay in the chosen state
independent of if there is a system installed or not at the receiving fax .
SLF2000 Users Manual
Page 21