Download C:\~TRICK WINGS\PRINTING\PRINTI

The wing core is shipped between the top and bottom beds. The
beds are used as construction jigs; so do not discard them.
There are three parts to each wing panel. The top of the wing can
be identified by its greater curvature. The left wing is the wing that
would be on your left if you were in the cockpit. The right and left
panels can be identified by the color mark at the root (the big end
of the wing panel): Red on the right.
DO NOT REMOVE ANY PRE-CUT PARTS AT THIS TIME!
There are three important pre-cut features on the wing panels. The
electronics bay and plywood spar channel are die-cut. These
come out as an assembly after joining the wing panels.
The servo bays are also die-cut. They are hard to see. An easy
way to find them is to rub the surface just behind the plywood spar
channel.
The four carbon fiber spar channels extend the full length of both
wing panels on both sides.
3