Download Mobotix Mx2wire

25/44
Preparing the Installation
Caution
Please avoid all direct contact with the circuit board (ESD) and only touch the edge of
the board in order to prevent damage arising now or later and to avoid reducing the
service life.
The in-wall socket used for Mx2wire+ must have an installation depth of at least 30 mm
and should be flush with the wall.
min. 30 mm
Note
If you do not have a standard in-wall socket available, you can also use the supplied
cavity socket for flush mounting.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]