Download E5AR-T E5ER-T Programmable Digital Controller User`s Manual

Section 4 Settings Required for Basic Control
■ Changing Parameters
Within each level, the parameter will change either forward or
backward each time the M Key is pressed. (The parameters will not
change backward in the Calibration Level.) For details, refer to
Section 8 Parameters.
Parameter changes forward
after M key is pressed for less than 1 second.
Parameter changes backward every
second when the M key is held down.
Parameter 1
M
Parameter 2
Settings Required
for Basic Control
Parameter 2
After holding down
M key for 2 seconds
M
Parameter 3
Parameter 3
Hold down the M key.
After holding down
M key for 1 second
After pressing
M key
Parameter 4
■ Saving Parameter Settings
• The first parameter will be displayed if the M Key is pressed when
the last parameter is being displayed.
• To change a setting, use the U and D Keys to change the setting
and then either wait for 2 seconds or press the M Key to save the
change.
• A change to a parameter setting is also saved when the level is
changed.
• Before turning OFF the power supply, always be sure that any
changes to parameter settings are confirmed (e.g., by pressing the
M Key). Any changes made with the U and D Keys that have not
been saved will be lost when the power supply is turned OFF.
4-4