Download User Manual

(2) this device must accept any interference received, including
WEEE Directive & Product Disposal
At the end of its serviceable life, this product
should not be treated as household or general
:I
I,
!.
i
t.
I
t
t
</
\ \1\zrt
/l-x
This battery is designed for separate coltection at
an appropriate collection point.
r
\
P:,H:l:::ffij,ilx::::j:ll,:?:li
o, o",
",
authoritiesin chargeofwaste management.
l
Changes or modifications not expressly approved by lhe party
responsible for compliance could void the user,s authority to operate
the equipment.
Compliance statement:
I
1 : Th is device is verified to comply with part 1S of the
FCC
Operation subject to the following two conditions:
(1 ) this device may nol cause harmful interfeience. and
i.
L
harmful interferenc in a residential installation.This equipmeot
Ru
I
I
installed And used in accordance with the instructions, may €use
harmful interference to radio communicalions. However.there is no
guarantee that interference will not occur in a particular inslallation.
lf this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to @rect lhe
interference by one or more of the following measures:
Caution:
l
for aclass B digital device, pursuant to part 15 of the FCC RulsThese Iimits are designed to provide reasonable proteclimagainst
generates, uses and can radiate radio frequencyenergyand, ifnot
This symbol on the battery indicates that the
battery is to be collected separately.
Thue follNing appty onty to users in European
L
I
2: This equipment has been tested and found to comply wilh the limits
Notice to customers:
ti
I
interference that may cause undesired operation.
waste. It should be handed over to the applicable
collection point for the recycling of electrical and
electronic equipment, or returned to the supplier
for disposal
les.
-
Reorient or relocate the receiving antenna.
-- lncrease the separation between the equipment and receiver.
-
Connect the equ ipment i nto an ouflet on a circuit different from
that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help
't
0