Download Users Guide

Chapter 5
5.5.3.4
Activation Backoff Period Setting
Syntax:
setting ActivationBackoffPeriod <number>
Description: Sets the Activation Backoff Period (seconds). The startup
process will wait the Activation Backoff Period and then
activate the ADSL line, when it is deactivated. The default value
is 0.
Example:
… adsl>setting BackoffPeriod 0
Sets Activation Backoff Period to 0.
5.5.3.5
LED Flash Time Setting
Syntax:
setting LedFlashTime <number>
Description: Sets the LED Flash Time, (when the line starts up, the sync LED
will flash). The LED delay time ON and OFF is controlled by
this time (100ms). The default value is 3 * 100ms.
Example:
… adsl>setting LedFlashTime 3
Sets the LED Flash delay time to 300ms.
5.5.3.6
SNR Threshold Setting
Syntax:
Setting SNRThreshold <number>
Description: Sets the SNR (Signal to Noise Ratio) Threshold. A SNR
Threshold alarm will be set when it is low. The default value is
22dB.
Example:
… adsl>setting SNRThreshold 22
Sets SNR Threshold to 22dB.
5.5.3.7
Syntax:
74
Attenuation Threshold Setting
Setting AttenuationThreshold <number>