Download Condition and Responsibility Guide
Transcript
Disabled facilities meet Australian Standards and building code requirements. Shower Water drains to a waste outlet point within the shower area and there is no ponding within the shower enclosure or leaks from the shower. Hobs are impervious to water. Shower roses and associated fittings operate to their designed capacity, with no leaking joints, and have no less than 75% of the applied finish intact. Shower screen is firmly fixed and clean. Frames have the greater proportion of the applied finish intact with only minor imperfections not resulting in a safety or hygiene risk. Where doors are fitted, they operate with ease and close to form an effective seal to contain shower water splashed within the shower. Shower glass is safety or wired glass free of cracking. Shower curtain rail is firmly fixed in position, straight in section length and able to support a curtain for its entire length. Towel rails Firmly fixed to attached surfaces, in a straight condition free of corrosion or surface deterioration and are clean and hygienic. Vanity Unit Unit is firmly supported and fixed into position. Unit carcass components are in a solid state, vermin proof, and able to be maintained in a hygienic state. Where replaced, unit to be on legs and tiled underneath with floor waste through wall cavity where possible. Unit top is water impermeable, free from significant delamination, holes, and open joints that provide an unhygienic surface. The splash back seals to the unit top, preventing water entering down the back of the unit. Unit doors and drawers are solid, operate smoothly without jamming or binding, and seat properly when closed. They are free from significant delamination and have surfaces that can be cleaned and maintained in a hygienic state. The drawer runners have no wear to hinder operation. Hinges, handles, locks and catches allow satisfactory use and secure in the closed position. Basin and tap/tapset are water proof sealed to the top of the unit. HOUSING ACT Responsibility Tenant Responsibility All of the above. Maintenance of fittings in a fully Keeping the bathroom and its operable condition. fittings in a clean, mould-free condition. Housing ACT Property Standards: Condition and Responsibility Guide 29