Download Condition and Responsibility Guide

Transcript
Disabled facilities meet Australian Standards and building code requirements.
Shower
Water drains to a waste outlet point within the shower area and there is no
ponding within the shower enclosure or leaks from the shower.
Hobs are impervious to water.
Shower roses and associated fittings operate to their designed capacity, with no
leaking joints, and have no less than 75% of the applied finish intact.
Shower screen is firmly fixed and clean. Frames have the greater proportion of
the applied finish intact with only minor imperfections not resulting in a safety or
hygiene risk. Where doors are fitted, they operate with ease and close to form an
effective seal to contain shower water splashed within the shower.
Shower glass is safety or wired glass free of cracking.
Shower curtain rail is firmly fixed in position, straight in section length and able to
support a curtain for its entire length.
Towel rails
Firmly fixed to attached surfaces, in a straight condition free of corrosion or
surface deterioration and are clean and hygienic.
Vanity Unit
Unit is firmly supported and fixed into position.
Unit carcass components are in a solid state, vermin proof, and able to be
maintained in a hygienic state.
Where replaced, unit to be on legs and tiled underneath with floor waste through
wall cavity where possible.
Unit top is water impermeable, free from significant delamination, holes, and
open joints that provide an unhygienic surface. The splash back seals to the unit
top, preventing water entering down the back of the unit.
Unit doors and drawers are solid, operate smoothly without jamming or binding,
and seat properly when closed. They are free from significant delamination and
have surfaces that can be cleaned and maintained in a hygienic state. The drawer
runners have no wear to hinder operation.
Hinges, handles, locks and catches allow satisfactory use and secure in the closed
position.
Basin and tap/tapset are water proof sealed to the top of the unit.
HOUSING ACT Responsibility
Tenant Responsibility
All of the above. Maintenance of fittings in a fully Keeping the bathroom and its
operable condition.
fittings in a clean, mould-free
condition.
Housing ACT Property Standards:
Condition and Responsibility Guide
29