Download PeakNet-PA Software User`s Guide

Transcript
8 • The Optimize Program
Type 2 peaks are partially resolved peaks. The peaks are
separated by a drop-line extending from the valley between the
peaks to a common baseline.
Type 3 peaks are host peaks fused with rider peaks (type 4, 6,
or 7) that have 20% or less of the height of the host peak.
Type 4 peaks are closely following rider peaks that are
separated from the host peak by an exponential projection of the
backside of the host peak. The area under the exponential line is
added to the host peak, not the rider.
Type 6 peaks are closely following rider peaks that are
separated by a tangential line from the host peak to the outer
edge of the rider peak. The area under the tangential line is
added to the host peak, not the rider.
Type 7 peaks are closely leading rider peaks that are separated
by a tangential line from the host peak to the outer edge of the
rider peak. The area under the tangential line is added to the
host peak, not the rider.
• Force Baseline
Forces a separate baseline between two Type 2 peaks where no
baseline is evident. To activate the event, move the Time-Scale
cursor onto the peak to the right of the area where you want to
force a baseline, then click first on the Force Baseline check
box and then on the Re-Integrate command button.
• Force Exponential Skim
If you separate a host peak (Type 3) from a closely following
rider peak (Type 4) by dropping a vertical line between them,
some of the area allotted to the rider peak is actually part of the
tailing slope of the host peak. The Force Expo Skim control
extrapolates the exponential decay rate of the tailing slope of
the host peak, and then adjusts the areas of the host and rider
peaks accordingly. Exponential skim is automatic when all of
the following conditions occur:
• The height of the rider peak is 20% or less of the height of
the host peak.
• The height of the valley between the host and rider peaks is
33% or more of the height of the rider peak.
Doc. 031322-02 2/02
8-19