Download PCE830/40 User Manual

PCE840
Analog I/O IDNs
Danaher Motion
Below is a list of the Analog Input and Output IDNs:
IDN
32809
34825
32810
32811
32812
Description
ADF0
AnalogIn
DM1F0
DM2F0
DM1GAIN
32813 DM2GAIN
32814
32815
34841
34842
Example
DM1MAP
DM2MAP
AnalogOut1
AnalogOut2
Function
Break Frequency for AnalogIn in Hz.
Analog Voltage Input
Break Frequency for AnalogOut 1 in Hz.
Break Frequency for AnalogOut 2 in Hz.
Gain for AnalolgOut1 – Scaling varies according to
function
Gain for AnalogOut2 – Scaling varies according to
function
Selects Variable to be mapped to AnalogOut1
Selects Variable to be mapped to AnalogOut2
Writes AnalogOut1 (if IEN 32814 = 0)
Writes AnalogOut2 (if IEN 32815 = 0)
User reads IDN 32825 (AnalogIn) to be 130.
Voltage on AnalogIn pin is:
1301000 = 0.13 volts
The analog input is a differential input to an A/D. The full scale
differential command input range is ±13V.
3.6.5. DACMap Parameters
IDN 32814
DM1Map selects the signal sent to the DAC Monitor 1 output on J2-4. This IDN
should be set so that:
IDN 32814 = Monitor # from the table on the following page.
IDN 32815
DM2Map selects the signal sent to the DAC Monitor 2 output on J2-5. This IDN
should be set so that:
IDN 32815 = Monitor # from the table on the following page.
Set the value of the DM1Map and DM2Map (IDNs 32814 and
32815) before setting the values of DM1Gain and DM2Gain
(IDNs 32812 and 32813).
IDN 32812
DM1Gain sets the multiplicative scale factor applied to the DM1Map selected
signal before outputting on DAC Monitor 1 (J2-4) (DM1Gain). This IDN should
be set so that:
IDN 32812 = DM1Gain*100
3-46
PCE830/40 User Manual