Download CAAPE User`s Manual

Using Application Files
Figure 7–9. Graphical Logic Print Page Setup - Headers
7.13.3.3
Printing and Print Preview
Go to File | Print Preview to preview the print; go to File | Print to print.
7.13.3.4
Logic Information File
This file provides relay state information that is not contained in the main logic file used
by the compiler. If the logic file was created from graphics, this file is also created
automatically. If the logic file did not come from graphics but the logic printout must
reflect relay states:
•
Manually create a Logic Information File: use Add File to Application to add a .VTI
or .NVI file, and then edit the file to set the states. The file consists of a LOGIC
STATE SECTION header followed by a list of relay states on one or more lines. The
state for relay “x” is specified by entering “x=T” for normally closed and “x=F” for
normally open.
•
Import the logic file into a logic component, edit the component to set the desired
relay states, and then export the component back into text files. Since exporting the
component changes the format of the main logic text file, temporarily save it
somewhere else and then copy it back after the Logic Information File is created.
P2512A, Rev. F, Nov/13
7–43
Alstom Signaling Inc.