Download EQUICALOR®

300546US-03-14
QUICK GUIDE
 INSTALLING THE EQUICALOR SYSTEM
1) Identify the zones
Plan out the division of the house into zones, determining
the quantity.
2) Define a position for the chronothermostat
The chronothermostat measures the temperature of the
room where it is installed; therefore, it must be in a position
exposed to good air circulation, at 5 ft above the floor. See
Typical placement of device on pg. 10.
3) Chronothermostat wall installation
Secure the chronothermostat in the desired position and connect it to the boiler. Refer to Wall installation on pg. 11.
CAUTION! Make sure to cut-out the mains voltage to the
electrical system before carry out this procedure.
4) Insert the batteries in the chronothermostat
The chronothermostat requires 3 AA 1.5 V Alkaline batteries. To
insert the batteries refer to Battery replacement on pg. 5.
5) Setting the language, date and time
Enter the data for first start up, as indicated in the paragraphs Current language, Date and Time (Set time) on pg.
7. To use the control keypad see Chronothermostat Configuration and Menu Navigation on pg. 6.
6) Configuring the zones
Set the number of zones in the house, as indicated in the paragraph Number of managed zones on pg. 19. To access the
function refer to Chronothermostat Configuration on pg. 6.
7) Insert the batteries in the actuator
Each actuator requires 3 AA 1.5 V alkaline batteries. To insert
the batteries refer to Battery replacement on pg. 16.
8) Installing the actuator
Install the actuators on their respective radiators. Refer to
Installing the actuator on pg. 17.
9) Associate all the actuators to the chronothermostat and
test them
Refer to the chapter Association of an actuator with the
chronothermostat on pg. 19.
INDEX
1. CHRONOTHERMOSTAT
Features of the chronothermostat
Contents of the package
Display and control keys
Warnings
List of alarms
Chronothermostat conditions of warranty
Contacts
Battery replacement
Operating modes
Chronothermostat configuration
Automatic temperature setting
Installing the chronothermostat
Technical characteristics of the chronothermostat
pg. 3
pg. 3
pg. 3
pg. 4
pg. 4
pg. 4
pg. 4
pg. 5
pg. 5
pg. 6
pg. 9
pg. 10
pg. 12
2. ACTUATOR
Features of the actuator
Contents of the package
Led indicator and front selector switch
Warnings
Technical characteristics of the actuator
Battery replacement
Remote sensor
Room comfort temperature adjustment
Installing the actuator
Manual release
pg. 14
pg. 14
pg. 14
pg. 14
pg. 15
pg. 16
pg. 16
pg. 16
pg. 17
pg. 17
3. TECHNICAL SECTION
3 . 1 (CHRONOTHERMOSTAT)
Chronothermostat - setup
Association of an actuator with the chronothermostat
 3 . 2 (ACTUATOR)
Actuator – setup

pg. 18
pg. 19
pg. 20
4. FUNCTION NAVIGATION MAP
pg. 22
5. APPENDIX
pg. 23