Download Lentivector Expression Systems:

Transcript
System Biosciences (SBI)
3.
User Manual
Infect target cells by adding the prepared virus. We suggest using several amounts of pseudoviral stock
(example: 1μl, 5μl and 10μl of virus). In addition, we recommend including a transduction well with a
copGFP positive control construct virus and other appropriate positive and negative control construct virus
preparations. Incubate cells at 37°C with 5% CO2 overnight. For extremely fast-growing and metabolizing
cell lines, such as 293T, use 3% FBS in the medium.
Day 3.
4.
Remove the culture medium and replace with 1 ml of complete medium (without Polybrene). Incubate the
cells at 37°C with 5% CO2 overnight.
Day 4.
5.
By day 4, the culture will be confluent (depending on cell type). Split it 1:3 to 1:5, depending on the type of
cells, and continue incubating for 48 hours in complete D-MEM.
Day 6.
6.
Page 14
The infected target cells can be analyzed for transient expression of the expression construct using an
appropriate biological assay. If you have used an internal copGFP control, determine the percentage of
infected cells by counting fluorescing cells by flow cytometry. Alternatively, the infected cells can be
identified by selecting and counting based on selection marker genes contained in the expression construct
(e.g., puromycin), but the titer determined by puromycin selection is usually less than the titer determined by
copGFP selection.
ver. 080707
www.systembio.com