Download MX8x8DVI-Pro user manual

Control commands:
Legend :
xx*
=
input number in 2 digit ASCII format (01,05,07 etc.)
yy*
=
output number in 2 digit ASCII format
CrLf =
Carriage return, Line feed (0x0D,0x0A)
Ԯ
space character (0x20)
=
1. Switch one input to one output ( Audio / DVI / RGB / SDI / Video)
Command
Response
{xx@yy}
(OyyԮIxx)CrLf
{01@05}
(O05 I01)CrLf
Description: Switch input xx to output yy.
Example: Connect input 1 to output 5.
2. Switch one input to all outputs ( Audio / DVI / RGB / SDI / Video)
Command
Response
{xx@O}
(IxxԮAll)CrLf
{01@O}
(I01 All)CrLf
Description: Switch input xx to all outputs.
Example: Switch input 1 to all outputs.
3. View connection on the specified output ( Audio / DVI / RGB / SDI / Video)
Command
Response
{?yy}
(OyyԮIxx)CrLf
{?05}
(O05 I01)CrLf
Description: View connection on output yy.
Example: View connection on output 5.
4. View connection on all outputs ( Audio / DVI / RGB / SDI / Video)
Command
Response
{VC}
(A
2
4
O8)CrLf
Description: Response length depends on the number of outputs installed in the
router. The response above suppose a router having 8 outputs. Indexes show the
actual output and the number at the given index shows which input it is connected
to. If value O5 equals 04 it means that output 5 is connected to input 4.
O1..O8 are two digit ascii characters. (01, 02, 04, etc.)
Example: View connection on all outputs
Command
Response
{VC}
(A
2
4
)CrLf
Legend: output 1 is connected to input 1, output 2 is connected to input
2...output8 is connected to input 8, this is the so called „diagonal pattern”.
Page 22 / 53