Download Programmer`s Manual

The Harmonizer® Programmer’s Manual
The IN and OUT “Modules”
H8000 family and Orville
H8000 and Orville programs are loaded and run one at a time on a given DSP. The DSP running the
program provides the program with four or eight
channels of input audio (where that input audio comes
from is a function of the routing configuration, see the
Harmonizer’s User Manual). The DSP running the
program also takes the four (or eight) channels of output
audio from the program (where it is subsequently sent is again a function of the routing configuration).
H7600 and DSP7000
The H7600’s programs are loaded and run on its single DSP. The DSP provides the program with two
channels of input audio and takes two channels of output
audio from the program. The remainder of this manual
will show Orville-style four channel processing, but the
idea is the same with the H7600’s two channels. If you
send a program that has more than two inputs or outputs
to your H7600 from VSigfile, it will not be accepted.
In the simplest of conceivable programs, the IN module’s
outputs are connected directly to the OUT module’s inputs
(this is the Thru’ program in bank 0). Normally, other, optional
modules are inserted in-between the IN and OUT modules.
The IN and OUT modules always remain as part of the program.
© 1999-2008 Eventide, Inc.
Page 67 of 97
Release 1.3