Download Additions and corrections for the STM3210E

STM3210E-EVAL
Errata sheet
Additions and corrections for the
STM3210E-EVAL user manual (UM0488)
Introduction
This errata sheet describes late additions and corrections to revision 1 of the STM3210EEVAL evaluation board user manual (UM0488). These changes are related to:
■
Version of demonstration software on the evaluation board
■
NOR Flash description (section 1.20 of UM0488 revision 1)
■
NOR Flash schematics (figure 26 in UM0488 revision 1)
Version of demonstration software
To use the STM3210E-EVAL evaluation board, you must have the demonstration software
version 1.1 or later. If the version of the software installed on your evaluation board is earlier
than version 1.1, you must download the latest version from the ST microcontroller support
site at www.st.com.
To check the version number of the demonstration software on your evaluation board, from
the main menu select About. The version number of the software is displayed on the LCD.
NOR Flash description
The following information needs to be added to the information present in revision 1 of the
STM3210E-EVAL evaluation board user manual:
Three different NOR 128 Mbit references can be present on the evaluation board depending
on component availability.
Table 1.
NOR Flash reference
Reference
Manufacturer
M29W128GL70ZA6E
NUMONYX
M29W128GH70ZA6E
NUMONYX
S29GL128P90FFIR20
SPANSION
These three references are not identical in terms of ID code, speed, timing, block protection.
The demonstration firmware and the software library delivered with the board support these
three NOR Flash references. However, during the development of your application software,
you must verify which NOR reference is implemented on your board (component referenced
as U2 on silkscreen and schematic), and take its specificities into account.
NOR Flash schematics
The schematics provided in Figure 1 replace the SRAM and NOR Flash schematics shown
in revision 1 of the STM3210E-EVAL evaluation board user manual.
June 2008
Rev 1
1/4
www.st.com
2/4
FSMC_INT2
FSMC_NE2
FSMC_NWE
FSMC_NOE
FSMC_NWAIT
D1
E6
+3V3
IS61WV51216BLL-10MLI
VSS
VSS
VCC
VCC
D6
E1
G1
F1
F2
E2
D2
C2
C1
B1
G6
F6
F5
E5
D5
C6
C5
B6
R13
10K
+3V3
100nF
100nF
C20
C63
C10
100nF
R19
10K
+3V3
D15
D14
D13
D12
D11
D10
D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
A5
B5
A4
G2
F2
F7
B4
B8
C5
D4
D5
C4
B3
E7
D7
C7
A7
B7
D6
C6
A6
B6
A3
C3
D3
B2
A2
C2
D2
E2
VCC
VCC
VCC
VSS
VSS
VSS
DQ15A-1
DQ14
DQ13
DQ12
DQ11
DQ10
DQ9
DQ8
DQ7
DQ6
DQ5
DQ4
DQ3
DQ2
DQ1
DQ0
10K
R12
Default setting: Open
+3V3
JP5
M29W128GH70ZA6E
M29W128GL70ZA6E
S29GL128P90FFIR20
W
RP
RB
G
E
BYTE
Vpp/WP
A22
A21
A20
A19
A18
A17
A16
A15
A14
A13
A12
A11
A10
A9
A8
A7
A6
A5
A4
A3
A2
A1
A0
U2
G5
F1
D8
H2
H7
E8
G7
F6
G6
F5
G4
F4
G3
F3
E6
H6
E5
H5
H4
E4
H3
E3
+3V3
C75
100nF
FSMC_NCE2
D15
D14
D13
D12
D11
D10
D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
0
R22
10K
R23
C62
100nF
PD7
+3V3
C15
100nF
16
17
18
8
9
A16
A17
2
WP
RB
VSS
VSS
VDD
VDD
19
7
13
36
12
37
+3V3
Rev: D.2(PCB.SCH)
Date: 2008-05-21
Sheet 11 of
STM3210E-EVAL SRAM&FLASH
Number:MB672
Title:
do not fit
R25
R24
10K
+3V3
C21
100nF
100nF
100nF
C24
C88
Rev D.2 modification : references of NOR flash used for U2 updated
Default setting: 2<->3
NAND512W3A2CN6E
NAND512W3A2BN6E
CL
AL
W
R
E
I/O0
I/O1
I/O2
I/O3
I/O4
I/O5
I/O6
I/O7
U3
STMicroelectronics
JP7
29
30
31
32
41
42
43
44
D0
D1
D2
D3
D4
D5
D6
D7
3
R17 R18
10K 10K
+3V3
CE
WE
OE
BLE
BHE
I/O15
I/O14
I/O13
I/O12
I/O11
I/O10
I/O9
I/O8
I/O7
I/O6
I/O5
I/O4
I/O3
I/O2
I/O1
I/O0
A22
A21
A20
A19
A18
A17
A16
A15
A14
A13
A12
A11
A10
A9
A8
A7
A6
A5
A4
A3
A2
A1
A0
1
R20
10K
+3V3
B5
G5
A2
A1
B2
A18
A17
A16
A15
A14
A13
A12
A11
A10
A9
A8
A7
A6
A5
A4
A3
A2
A1
A0
U1
PG6
0
R16
10K
H1
D3
E4
F4
F3
G4
G3
H5
H4
H3
H2
D4
C4
C3
B4
B3
A5
A4
A3
PG9 R21 0
PD5
PD4
PD6
PE0
PE1
R15
+3V3
A18
A17
A16
A15
A14
A13
A12
A11
A10
A9
A8
A7
A6
A5
A4
A3
A2
A1
A0
D[0..15]
A[0..23]
11
Figure 1.
FSMC_NBL0
FSMC_NBL1
FSMC_NE3
PG10
D[0..15]
A[0..23]
STM3210E-EVAL
SRAM and Flash
STM3210E-EVAL
Revision history
Revision history
Table 2.
Document revision history
Date
Revision
2-June-2008
1
Changes
Initial release.
3/4
STM3210E-EVAL
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2008 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
4/4